Whether you have rolled a brand new car out of the showroom or you own an old car, you must ensure that the exterior shine is well preserved even after using the vehicle for years. When you’re driving, you’ll encounter rocks, trash, and other debris that can scratch your car’s paint. Fixing these scratches can cost a lot of money, you need to get a solution before actually facing the problem. You can protect your car with Paint Protection Film, or PPF. It’s like a clear shield for your car’s paint, which guards your vehicle’s exterior paint against scratches, sunlight, chemicals, and dirt. In this blog, we will explain how to use PPF Installation Tools so that you can make sure the PPF is installed perfectly. Essential PPF Installation EquipmentBefore you start installing PPF, make sure you have all the required PPF Installation Tools. Below mentioned are some equipment that must be equipped with every PPF installer: Guide to Installing Film Using PPF ToolsStep 1: Getting Your Car ReadyFirst, you need to clean your car well. This means washing it with special car cleaning products, soft cloths, mitts, and sponges. Make sure both the outside and inside are clean, especially if your car is pretty dirty. After washing, use a clay bar gently on all parts where you’ll put the film. Dry the surface using high-quality microfiber towels so that every part where you’re going to apply the film is dry and dirt-free. Protect the parts on the edges of the vehicle with masking tape before rubbing and polishing. Step 2: Putting On the FilmIt’s best to have small panels at a time, starting in the middle and working your way out. This lets you be more precise. It might take a while, so don’t be impatient. On a clean surface, spread the slip solution with the help of sprayers. Use a squeegee to press the film onto the car. This helps avoid air bubbles and makes sure the film sticks properly. Before you start, check again for any dust or dirt that might get trapped under the film. Step 3: Prepping the Surface with SolutionBefore you put the film on, you need to use a special solution called a slip solution. This makes it easier to handle the film and stops dirt from sticking to the sticky side. A soap solution works well too because it keeps dirt off, which is great for keeping your film looking good for a long time. When you use the slip solution, just put on a light layer over where the film will go. Don’t use too much, or it might mess up how well the film sticks. Step 4: Cutting and Applying the FilmYou can put the film on in two ways: wet or dry. The wet way means you spray adhesive on the car first, which is good for tricky spots because it makes everything smooth. But it takes patience to cut and apply each piece. The dry way means you stick the film directly on the car, which is quicker for big areas but might leave bubbles or wrinkles if you’re not careful. Choose the method that works best for you, and then start applying the film bit by bit. Press down gently with a cloth or squeegee to make sure it sticks. Step 5: Making Sure It’s Done RightIt’s important to make sure the film is installed without any errors. This means you should check if the size, cutting, and installation of the film are done properly. Remove all the air bubbles and smoothen out the surface. Why You Should Pick The Detailing Mafia for PPF InstallationInstalling paint protection film is always a wise decision to keep it looking good for a long time. Sure, you can do it yourself with the right tools, but it’s better to let the experts handle it. If you’re in India and want to experience top-notch care for your car, go to The Detailing Mafia. Our team knows how to use PPF Installation Tools effectively and will make sure your vehicle gets the best treatment possible. Don’t wait any longer to shield your car’s paint. Get in touch with the professional and skilled team of The Detailing Mafia now to schedule your paint protection film installation.
